The NO nonsense guide to

water fuel conversion for

road vehicles

Can a car run on water?

Sounds too good to be true but in fact it is certainly possible to run your car on water supplemented by gasoline. Furthermore with the right instruction guide you can easily build your own conversion-kit. The technology has been around for years but until very recently the only way to convert your car to water was to have it done by a professional, costing as much as $2,500. Even the few "stand-alone" kits around cost over $500. But now soaring fuel costs have together with increased environmental awareness have meant a number of affordable and safe conversion-kit guides have appeared within the last few months. With the right information a complete novice can safely turn a car into a hybrid within a few hours.

Conversion-kits show the non-expert how to build and install a simple converting device that uses low cost materials bought at a local store. The installed device can easily be taken out and transfer from one vehicle to another.

The benefits are clear. Not only does this dramatically cut your gas bill by roughly half, it significantly reduces carbon emissions(pollution). Greatly improved efficiency means a much smoother ride. Once up and running and now classified as a hybrid you are entitled to IRS refunds owed by law to you in the US for using green technology in your vehicle.

That said, it is not for everyone. If you already have a hybrid or electrical vehicle or spend less than $100 on gas a month then conversion doesn’t make sense.

How does it work?

Hydrogen is extracted from water to supplement the existing fuel. It is very easy to extract this energy from water and run your car on it. Water makes a far more efficient energy source than the regular fuel you use in your car.

With the regular fuels we all normally use, our cars engine only uses 20% of the energy stored in that expensive fuel. The other 80% is wasted into heat, pollution and vibration.

At present it is not possible to run a vehicle on water alone. You still need gas.

Depending on a number of factors you may only get a fuel efficiency saving of 50-60%. Your car engine size, the size of the water conversion kit you install directly affect its efficiency.

Won’t it damage my car?

The device you make and install is very simple. There are no engine, fuel injection or vehicle computer adjustments to make. It just as easily be taken out as put in.

Your engine is being damaged by unburned fuel every time you use it. A good, well-installed conversion kit helps not only eliminate carbon deposits caused by unburned gasoline it will actively clean out your engine whenever it is in use. After a few weeks you will notice a smoother ride as the engine gets close to optimum efficiency and stream-cleans itself.

However if badly installed it may damage your vehicle and void your warranty. That said, it is a simple process by anyones standards which with the right step-by-step guide (and guide support) anyone should be able to do.

Which kit guide?

It goes with out saying choosing the right guide is absolutely essential to the conversion success. You don’t want instructions from anyone but an expert. For selecting the best kit guide the criteria we set were:  

   

Significant fuel savings – a minimum saving of 40% of fuel efficiency  Quick and simple installation – 3 hours maximum for novices  Setup costs – under $100

There are over 30 water conversion-kit guides available on the internet. As you might expect most of these are either too complex or simply don't work. Three stood out as fully recommendable and these we have reviewed below.